Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.

Coolrunner rev. C and QSB install

  • 31-05-2012 05:43PM
    #1
    mayto
    Registered Users, Registered Users 2 Posts: 856 ✭✭✭


    I just installed nand-x and coolrunner qsb's to a phat Jasper. I read the nand with j r programmer, but am a bit confused of how to solder up the coolrunner. I will be doing the rgh 2.0 install. I think B and 3v3 are soldered to the coolruner qsb, but not really sure after that. I cannot find any guide using coolrunner rev.C and the qsb's. Wire install here http://www.xecuter.com/forums/showthread.php?t=86539


Comments

  • #2
    Jimbobjoeyman
    Registered Users, Registered Users 2 Posts: 808 ✭✭✭Jimbobjoeyman


    You dont use the quicksolder boards with 2.0
    Its a direct wire install only


  • #3
    mayto
    Registered Users, Registered Users 2 Posts: 856 ✭✭✭mayto


    I soldered the e and f points under the motherboard. I got it working after a lot of messing about. First off my win 7 laptop did not like writing the ecc and just got errors. Xbox would not boot then and I thought it was bricked. But I could write the nand I read back to the 360 and start again with an xp laptop. My win7 just did not like jr programmer and j runner. The xecuter forums are run by real arrogant snobs, you would nearly be afraid to ask a question for the abuse you could get :eek:. The glitch generally takes a few min to boot but does not bother me atm, will look in to improving boot times at some stage.


  • #4
    Hangover
    Registered Users, Registered Users 2 Posts: 207 ✭✭Hangover


    mayto wrote: »
    I soldered the e and f points under the motherboard. I got it working after a lot of messing about. First off my win 7 laptop did not like writing the ecc and just got errors. Xbox would not boot then and I thought it was bricked. But I could write the nand I read back to the 360 and start again with an xp laptop. My win7 just did not like jr programmer and j runner. The xecuter forums are run by real arrogant snobs, you would nearly be afraid to ask a question for the abuse you could get :eek:. The glitch generally takes a few min to boot but does not bother me atm, will look in to improving boot times at some stage.

    Did you use admin rights with win7 ? IE, right click and run as administrator - i do this with all jtag programs under win7.


Advertisement