Storage Heating Control Issues

shaunevans

I have recently moved into a new apartment and am having some problems working out how to control my storage heating.

The heater is a Creda Superslim Combi storage heater and has manual controls for input and output under a panel on the top. I could figure out out how to use it if these were the only controls.

However there are two thermostat looking devices in the apartment one marked "master control for all storage heating" and another marked "room temperature boost control"

I don't know which controls to use either the thermostats or the heater controls and what positions to place them in.

I'm attaching photos as i'm not too sure how good my descriptions are.

Thanks very much

mazthespark

the thermostats usually break the supply to the heater while its operating. eg. if u have the boost turned on and the relevant stat set low once the temperature reaches this the boost will turn off. same goes to the storage side of the heater. this works at night and if the stat is again set and the room is warm enough the stat will operate cutting supply to the heater and it wont be charging up for the morning. hope that all makes sense

shaunevans

Thanks very much I hope it works like that

mazthespark

easy way to test turn on your boost and turn the boost stat way down (until u hear a click usually) and could also try with the storage one but be careful u will have on heat then the following day only boost