Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

VoIP Setup Nightmare

  • 14-09-2007 1:01am
    #1
    tranceenigma
    Registered Users, Registered Users 2 Posts: 155 ✭✭


    Hi There,

    I am attempting to setup VoIP with Blueface (PAYG Ac) on my broadband connection, Just to describe my setup:

    BB Provider: Permanet Wireless Broadband
    Hardware: Arris Cable Modem CM450
    Wireless Router: Linksys WRT54GSV4
    ATA: Linksys PAP2 Phone Adaptor
    Phone: Standard Analogue Eiircom Phone


    I am having a few problems here, thought it would be a case of just loggin into the ATA & putting in my blueface details to the device & off I go - far from it.
    I am not gettin any Dial tone, from the unit, also on the PAP2 HTTP interface under 'Line 1 Status' I am gettin the following:

    'Registration State: Can't connect to login server'

    So I assume it cannot get properly connected to blueface here, when I ping sip.blueface.ie from my laptop it Pings 100%.
    I have been told that my Arris BB Modem is set to DHCP & also my Linksys Router is set to DHCP & that is where there may be a possible problem, the SIP protocol in the ATA is gettin confused & cannot route its way out through my network setup.

    I have attempted also to connect the ATA directly to the Arris Modem, therefore bypassing the Router & tried to get a connection but nothing.
    The ATA does not even pick up a valid IP Address from the cable modem after I reset the unit. In this case it should be gettin 192.168.176.x but no matter what I do its always getting 192.168.1.101 & yes its set to DHCP.

    Its problems in every direction really & I seem to be getting no results, i have tried reading all the doucmentation on the net & still no good, do I need to setup portforwarding or something like UDP or uPnP settings on my linksys router & then would everything be ok??

    A lot of questions - no answers??

    Help Please would be much appreciated....


Comments

Advertisement