Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Raft Foundation Detail

  • 19-04-2021 7:51am
    #1
    Hurler85
    Registered Users, Registered Users 2 Posts: 160 ✭✭


    Hi,

    Just got raft foundation details back off my engineer for new house build. I see the radon barrier is called up over the concrete slab of the raft. While I see it’s a common detail, doesn’t l this mean that the membrane is exposed until floor insulation is put down which would mean risk of puncturing from construction works? Would it not be better to place under concrete and eliminate this risk? TIA


Comments

  • #2
    Biker1
    Registered Users, Registered Users 2 Posts: 395 ✭✭Biker1


    Hurler85 wrote: »
    Hi,

    Just got raft foundation details back off my engineer for new house build. I see the radon barrier is called up over the concrete slab of the raft. While I see it’s a common detail, doesn’t l this mean that the membrane is exposed until floor insulation is put down which would mean risk of puncturing from construction works? Would it not be better to place under concrete and eliminate this risk? TIA

    It would be rare to not have it below the concrete for the reason you stated.


  • #3
    rayjdav
    Registered Users, Registered Users 2 Posts: 1,082 ✭✭✭rayjdav


    http://www.necoflex.ie/support/radon-barrier-solution-finder/ram-system/design/construction-detailing/construction-detailing-05.aspx

    Exactly the same issue with any build type, membrane exposed until last minute.


  • #4
    Bullocks
    Registered Users, Registered Users 2 Posts: 5,890 ✭✭✭Bullocks


    The last time we didn't put the radon barrier under the concrete we put strips of radon under the blocks when building then when we were ready to put down the screed we cleaned out everything off the strips, put on the mono bond radon tape allowing for a good lap and put down the floor/room sized pieces over the strips


  • #5
    P2C
    Registered Users, Registered Users 2 Posts: 251 ✭✭P2C


    My builder built a block on the inner leaf, added the floor insulation directly on top of the radon barrier (150mm) on the slab. Put a trim of insulation 1inch x 100mm around the perimeter and then poured the finishing slab 100 mm of concrete to the top of the insulation trim. Very easy to power float and nice smooth/ slab finish. I don’t have underfloor and it’s a domestic garage.


Advertisement