Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

HKC Quantum 70 beeping

Options
  • 27-01-2020 12:11pm
    #1
    KilOit
    Registered Users Posts: 2,985 ✭✭✭


    This started beeping last night on the panel, red light came on under the bell led. nothing on the panel to say what the fault was, entering the code deactivated it but it started doing it again 30 mins later.

    Alarm wasn't set so not sure why it would do this.
    I take it if it was low batt it would say? could a tamper battery cause this beeping sound even if it wasn't set? some tampers are wireless


Comments

  • Options
    #2
    altor
    Registered Users Posts: 11,643 ✭✭✭✭altor


    KilOit wrote: »
    This started beeping last night on the panel, red light came on under the bell led. nothing on the panel to say what the fault was, entering the code deactivated it but it started doing it again 30 mins later.

    Alarm wasn't set so not sure why it would do this.
    I take it if it was low batt it would say? could a tamper battery cause this beeping sound even if it wasn't set? some tampers are wireless

    If alarm is not set and you do get a tamper or other event like mains fail the system will beep, you put in your code to acknowledge same and it should tell you the issue.

    Have you the engineer code to check the log?

    www.altor.ie



Advertisement