If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)

Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.

Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Alt 65-50 shrink wrapper settings

GT95 · 2020-09-04 20:49:58

I'm am working on an L bar shrink wrapper at work. It's proving extremely difficult to get it setup to run consistently.. Its to wrap boxes in the range of 15cm x 13cm x 9cm. The main problem that occurs is the occurrence holes on the longitudinal side. Am using 100 gauge LDPE. The machine is an Alt 6550. Ifp in Italy are…

04-09-2020 9:49pm

#1

GT95

Registered Users Posts: 16 ✭

Join Date: September 2008

Posts: 5

I'm am working on an L bar shrink wrapper at work. It's proving extremely difficult to get it setup to run consistently.. Its to wrap boxes in the range of 15cm x 13cm x 9cm. The main problem that occurs is the occurrence holes on the longitudinal side. Am using 100 gauge LDPE.
The machine is an Alt 6550. Ifp in Italy are the manufacturer.

Best case it will run at about 80% 1st pass yield.

Has anyone experience of getting this type of machine set up to run properly?

Thanks,
GT

0