Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

HKC Reed Sensor Question

  • 15-05-2021 2:20pm
    #1
    cubix
    Registered Users, Registered Users 2 Posts: 2,161 ✭✭✭


    Hoping someone can point me in the right direction. The cover of the old sensor finanaly gave up the ghost and I am now getting an open zone on this unit. Thought I would get away with just replaceing the cover but newer unit is smaller. Can any tell me what goes where please.

    Old unit:
    Black is -12V
    Red is +12V
    Yellow is data
    Blue is unused
    Tappper is bridged

    New Unit
    Middle two scews are tapper
    Next pair of screws are sensor but done see any + or-
    Out pair are marked Reed/Spare


Comments

  • #2
    kub
    Registered Users, Registered Users 2 Posts: 6,555 ✭✭✭kub


    cubix wrote: »
    Hoping someone can point me in the right direction. The cover of the old sensor finanaly gave up the ghost and I am now getting an open zone on this unit. Thought I would get away with just replaceing the cover but newer unit is smaller. Can any tell me what goes where please.

    Old unit:
    Black is -12V
    Red is +12V
    Yellow is data
    Blue is unused
    Tappper is bridged

    New Unit
    Middle two scews are tapper
    Next pair of screws are sensor but done see any + or-
    Out pair are marked Reed/Spare




    Your new sensor is the wrong model, you should have gotten a Point ID Reed Sensor.


  • #3
    altor
    Registered Users, Registered Users 2 Posts: 11,766 ✭✭✭✭altor


    You will need engineer access to delete the old ID sensor and add a new one.

    www.altor.ie



Advertisement