Cutting rounded top on a fence panel

BrokenArrows · 16-04-2019 1:17pm #1

Im building a small section of fence. I already have the wood lying around so dont want to buy anything else.

Id like to have the tops of the posts to be rounded. See the picture for an example.
Are there any other methods available other than using a jigsaw?

EletricMan · 16-04-2019 1:21pm

Mark out the curve with a compass and use a belt sander. Or a coping saw. Jigsaw is the easiest option.

garv123 · 17-04-2019 12:34pm

Hand router with a bearing cutter, if you had access to one.

jigsaw and sand one to the shape your happy with and router the rest using the first one as your jig.

my3cents · 17-04-2019 2:06pm

garv123 wrote: »

Hand router with a bearing cutter, if you had access to one.

jigsaw and sand one to the shape your happy with and router the rest using the first one as your jig.

Aren't you going to get massive tear out on one side with a router on the end grain?

garv123 · 17-04-2019 3:50pm

my3cents wrote: »

Aren't you going to get massive tear out on one side with a router on the end grain?

Only did it once on a few pieces and they were ok, I did trim away most of the excess with a jigsaw tho.

My routering is usually all plastics tho, so no expert on timber.

listermint · 17-04-2019 4:54pm

my3cents wrote: »

Aren't you going to get massive tear out on one side with a router on the end grain?

No. You come in from each side and meet in the middle.

RoscommonTom · 17-04-2019 8:34pm

A planer should do the trick

Stoolbend · 21-04-2019 11:07pm

I did it myself a few years ago but I just used a jigsaw.

I used a paint tin to mark the curve.

antiskeptic · 22-04-2019 5:21pm

BrokenArrows wrote: »

Im building a small section of fence. I already have the wood lying around so dont want to buy anything else.

Id like to have the tops of the posts to be rounded. See the picture for an example.
Are there any other methods available other than using a jigsaw?

Cheap coping saw. It's a thin blade on a tall frame.

Calahonda52 · 23-04-2019 4:32pm

Stoolbend wrote: »

I did it myself a few years ago but I just used a jigsaw.

I used a paint tin to mark the curve.

+1 with the right blade: scrolling blade..
Cut 20 perfect circles yesterday with one, just needed a rub of sand paper

BrokenArrows · 23-04-2019 4:37pm

Thanks for the advice guys.
Ill go with the jigsaw route with some new blades.

Calahonda52 · 23-04-2019 5:14pm

BrokenArrows wrote: »

Thanks for the advice guys.
Ill go with the jigsaw route with some new blades.

Turn off the pendulum motion and take your time, have the piece well cramped and guide saw with two hands

Cutting rounded top on a fence panel

Comments