Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

Workbench build advice

Options
  • 25-11-2019 8:36pm
    #1
    BackInTown
    Registered Users Posts: 49 ✭


    Hi All,
    Realtive noob here. I’ve been reading along for a while but this is my first post. I’ve been building a workbench to (and it’s Paul Sellers design ... just due to the easy access to information).
    Unfortunately due to some miscalculation along my way... the width of my tool well board is a little narrower than the space now allotted to it. I had laminated two boards together to get what was supposed to be an appropriately sized well board.

    So now should I scrap that well board and start again with 2 or 3 new boards to make or should I try add to the existing laminate with a strip of approx 40mm

    Any advice welcome.


Comments

  • Options
    #2
    [Deleted User]
    Posts: 3,637 ✭✭✭ [Deleted User]


    BackInTown wrote: »
    Hi All,
    Realtive noob here. I’ve been reading along for a while but this is my first post. I’ve been building a workbench to (and it’s Paul Sellers design ... just due to the easy access to information).
    Unfortunately due to some miscalculation along my way... the width of my tool well board is a little narrower than the space now allotted to it. I had laminated two boards together to get what was supposed to be an appropriately sized well board.

    So now should I scrap that well board and start again with 2 or 3 new boards to make or should I try add to the existing laminate with a strip of approx 40mm

    Any advice welcome.

    Add a 40mm strip to it. Easily done.


Advertisement