Aftermarket Tool Rest for Record Grinder

Swift66 · 05-02-2021 9:08am #1

Hello,

I bought this grinder: https://www.recordpower.co.uk/support/page/product/prod/rsbg8-8-bench-grinder-with-40mm-whitestone-with-uk-plugnew, about a year ago and am just setting it up. The tool rests seem very sloppy, and only clicks into preset angles, so I want to get another one (or two). Primarily for chisels, plane blades and gouges, no turning tools. I see that the Veritas one has slots with a max stone width of 1 1/2"/ 38mm - so no good for the 40mm stone on this grinder.

Any other recommendations or tips?

Thanks

05-02-2021 9:25am

Swift66 wrote: »

Hello,

I bought this grinder: https://www.recordpower.co.uk/support/page/product/prod/rsbg8-8-bench-grinder-with-40mm-whitestone-with-uk-plugnew, about a year ago and am just setting it up. The tool rests seem very sloppy, and only clicks into preset angles, so I want to get another one (or two). Primarily for chisels, plane blades and gouges, no turning tools. I see that the Veritas one has slots with a max stone width of 1 1/2"/ 38mm - so no good for the 40mm stone on this grinder.

Any other recommendations or tips?

Thanks

There’s a wide blade accessory for the Veritas guide as an extra option

Swift66 · 08-02-2021 8:00am

Thanks JayZeus.

There's a "Table for 1-1/2" Wheels for Veritas Grinder Tool Rest" listed on the veritas site is that what you mean?

1.5" = 38mm and these are 40mm, do you have one , do they fit the 40mm wheels?

Thanks

08-02-2021 1:23pm

Swift66 wrote: »

Thanks JayZeus.

There's a "Table for 1-1/2" Wheels for Veritas Grinder Tool Rest" listed on the veritas site is that what you mean?

1.5" = 38mm and these are 40mm, do you have one , do they fit the 40mm wheels?

Thanks

Ah, that’s the one. If it were up to me, I’d widen the slot to suit. I don’t have one, but that will certainly do the job.

Swift66 · 09-02-2021 8:43am

Cheers!

Aftermarket Tool Rest for Record Grinder

Comments