Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Quatem 1070

  • 22-10-2019 7:56pm
    #1
    2012paddy2012
    Registered Users, Registered Users 2 Posts: 2,880 ✭✭✭


    To see if the hall pir worked I put on the alarm... Waved at it no activation this morning.

    So I just did same... Now..... Until I put my hand over the actual pir it didn't activate.. It did when I nearly touched it...
    It showed hall pir caused the event... It's working...

    I took it apart I was sure there was a button on the circuit board to increase sensiviry I can't find it...
    Is it increased from the RKP?
    WHAT setting it so?
    I washed the front tho it was clean...


    Any advice?

    I wanted to know is it ... soak mode ....or something that would allow me to test each zone in turn ...i recall Years ago... Some setting that allowed me to open each window zone as I did the alarm bell rang to show it tested correctly...

    Any advice?

    Thanks in advance

    Paddy


Comments

  • #2
    2012paddy2012
    Registered Users, Registered Users 2 Posts: 2,880 ✭✭✭2012paddy2012


    2012paddy2012 wrote: »
    To see if the hall pir worked I put on the alarm... Waved at it no activation this morning.

    So I just did same... Now..... Until I put my hand over the actual pir it didn't activate.. It did when I nearly touched it...
    It showed hall pir caused the event... It's working...

    I took it apart I was sure there was a button on the circuit board to increase sensiviry I can't find it...
    Is it increased from the RKP?
    WHAT setting it so?
    I washed the front tho it was clean...


    Any advice?

    I wanted to know is it ... soak mode ....or something that would allow me to test each zone in turn ...i recall Years ago... Some setting that allowed me to open each window zone as I did the alarm bell rang to show it tested correctly...

    Any advice?

    Thanks in advance

    Paddy

    Update!!!
    O#3 did a, walk test all zones are working.. Including the hall pir.... I notice it detects movement a bit further away since I cleaned it... Also while walk test.. ..pir showed a colour which is doesn't by default.


    So now... All I want to know is the sensitivity ...to increase it....
    I'm nearly sure there is a switch on the PIR ...i hold off talking it down again... Till I get a bit of advice... Thanks for reading...


Advertisement