Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Gas Boiler Flue Gas Analysis

  • 28-07-2020 8:40pm
    #1
    John.G
    Registered Users, Registered Users 2 Posts: 3,563 ✭✭✭


    Came across this analysis which was issued with the declaration of conformance for new installation for a Vokera Vision 20s installed 4 years ago and operating perfectly since.

    Do the very low temperature readings just mean that the analysis was taken without allowing the boiler to heat up?.


Comments

  • #2
    DGOBS
    Hosted Moderators Posts: 3,496 ✭✭✭DGOBS


    Yeah I'd guess so, just on start up by the looks of it.


  • #3
    John.G
    Registered Users, Registered Users 2 Posts: 3,563 ✭✭✭John.G


    I also notice that the magnetic filter is installed between the flow&return just before the HW cylinder which means that there is a full by pass at all times, the filter should ideally be installed in the return just before the boiler but since it was installed with the complete new system will be ok from that point of view.
    The big up side of all this though is that even with only one rad, ~ 1.5 kw , in service, the boiler which has a min output of ~ 5.5kw will cycle on/off as it must but with no problems which some boiler makes seem to have all sorts of problems with when cycling, I just wonder if the filter was installed "properly" would the Vokera behave similarly.


Advertisement