Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.

Aspire Natilius Mini problems

  • 16-01-2016 11:38PM
    #1
    Snowshower
    Registered Users, Registered Users 2 Posts: 88 ✭✭


    Hi folks..bought the above online (irish site) with some extra coils....but have nothing but problems with them...(bought same set up previously from same vendor and worked fine) except I broke the wire in the bottom hardware when cleaning...new coil works fine for a little while, then the gurgling starts and the whole thing is flooded...changed coils, washed out...same again. Even changed the coil from a different pack..Checked YouTube it said put extra plastic ring on coil..did that still the same....any advice for a different set up....using istick 30 which is brilliant.

    Thanks


Comments

  • #2
    PHUNDAPUSS
    Registered Users, Registered Users 2 Posts: 20 ✭PHUNDAPUSS


    i find aspire to be a nightmare for gurgling, but usually turning my watts/ volts up or down helps. i do have to do the oul flick to get the excess juice from the chimney


  • #3
    youdipstick
    Registered Users, Registered Users 2 Posts: 2,555 ✭✭✭youdipstick


    Snowshower wrote: »
    Hi folks..bought the above online (irish site) with some extra coils....but have nothing but problems with them...(bought same set up previously from same vendor and worked fine) except I broke the wire in the bottom hardware when cleaning...new coil works fine for a little while, then the gurgling starts and the whole thing is flooded...changed coils, washed out...same again. Even changed the coil from a different pack..Checked YouTube it said put extra plastic ring on coil..did that still the same....any advice for a different set up....using istick 30 which is brilliant.

    Thanks

    It can only be the coils that are at fault,I have 8 mini nautilus's on the go for the past couple of years & only had one problem with one of them,gurgling & that was a bad coil.
    You are using the Aspire BVC coils because the BDC Aspire coils were crap.
    For another set-up,the only other mouth to lung clearo that I use is the Innokin Iclear 30 & the Iclear 30s,been using these for over 3 years & still going strong,only a tenner each as you know.Everything else I use is sub ohming.
    They say the Cubis is a good mouth to lung but some reviewers say they leak a little at every fill.
    Maybe somebody else can chime in here with advice.


Advertisement