Enclosed chain came off

sleepyholland · 08-12-2015 08:22PM #1

So the enclosed chain came off my wife's bike.
It's a cheap, lightweight single-speed Cinzia Bombi that has served her well up until now.

The chain seems to have fallen off the front chainring. There is no obvious way of opening the enclosure without destroying it. Anyone ever deal with one of these?

https://us.v-cdn.net/6034073/uploads/attachments/86377/84665.jpg

Craig06 · 08-12-2015 08:50PM

I dunno but maybe you have to take the crank off?

Lumen · 08-12-2015 08:59PM

The chain case will be held together with clips and/or small screws. It's difficult to advise precisely without seeing proper close-up pics of it.

Lumen · 08-12-2015 09:04PM

Bigger pic found.

The case will come off over the crank, with the pedal removed, although you probably won't have to take it off completely to get the chain back on.

(source pic has now disappeared)

sleepyholland · 08-12-2015 09:16PM

thanks Lumen.
Can't see any liittle clips or bolts, maybe it's just clamped together with glue and rust. I'll take off the pedal and try prising it open!

ted1 · 08-12-2015 09:27PM

What's it like in the other side ? Can you lift the chain up with a rod/ screwdriver and get it on to the ring ?

sleepyholland · 08-12-2015 09:30PM

afraid not - looks like zero access.
(well a tiny tiny bit, but barely wiggle room for a screwdriver)

Wishbone Ash · 08-12-2015 09:36PM

Before you go damaging the cover, loosen the bolts on the drop outs and place the bike on its side - (the opposite side to the side the chain has come off). Turn the pedals and see if this will engage it. The chain may be worn - either replace it on move the wheel further back.

Esroh · 09-12-2015 12:22AM

The cover should just pop off.
If you look at the attached photo and there is no slide out piece(I cannot see it on your pic) You will have to remove the pedal to get it off completely.
If you slide a blade around the edge just clean out any dirt which is causing a seal you should be able to pop it off with a bit pf pressure. Although it seems flimsy it is harder than u think to damage it. ( I have removed a few rusted in for years on High Nellys)

sleepyholland · 09-12-2015 08:58AM

thanks all - I'll get a chance to look at it tonight.
I'll look for a slide out piece but don't recall seeing one.
The enclosure feels very flimsy but a blade will probably free up both sides.

Peterx · 09-12-2015 09:46AM

No help to you but this type of situation does bring to mind the great Douglas Adams;

"The major difference between a thing that might go wrong and a thing that cannot possibly go wrong is that when a thing that cannot possibly go wrong goes wrong it usually turns out to be impossible to get at or repair"

sleepyholland · 21-12-2015 03:09PM

The blade slide, pop off approach worked.
However, after putting it all back together it wasn't long before the chain popped off again. The back wheel has a buckle which seems to be dragging the chain out of line. Can these wheels be repaired/trued or is it whee- replacement time?

Esroh · 21-12-2015 04:10PM

The wheel can be sorted but the buckle in the wheel should not effect Chain Tension if the axle nuts are tight enough to prevent the hub moving.
My guess is that you have Chain Stretch and that the axle nuts are not holding everything in place once you put pressure on the pedals.
Getting the axle nuts tightened enough means tighten, tighten and tighten again
Again I only going on experience with Old High Nelly but they all had a Chain tensioner . Looking at the Photo posted above there does not seem to be one might be worth looking into.

Enclosed chain came off

Comments