How much is a Trex 600 cf worth?

There is no radio included although the AR7000 receiver is....
It's electric and comes with two Thunder Power 5amp 22v batteries - both in good condition.
It has a flybar....
Receiver battery is a NI-MH 2.4amp - .Also there is a voltmeter installed....I charged all three batteries up a few days ago and everything seems fine with them....
I haven't checked the 22v batts properly though because at the moment the heli isn't programmed into my radio.

So the spec is@
AR7000 spektrum receiver....
CSM SL630 gyro....
Brushless Align RCM-BL600M Motor
1x S9254 Futaba servo for the tail rotor
3x Spektrum DS821 for the main rotor.
Sanyo 2.4amp NI-MH - I think it's 4.8 volt.

I can't see the model number of the speed controller but I assume it's standard....I'll pull it out if this needs to be confirmed....

A nice lot of spares too....I have no main blades but I'll get them if it's needed for a sale....
All in all the heli needs a good going over to make sure everything is setup correctly.

I haven't used it in a long time but if this is required to be done I can do it; there is probably no point I'd imagine seeing as the radio is not included.

I'm assuming a buyer would want to do it themselves anyway.

See photos....
https://www.dropbox.com/sh/h5674mvd7qpaggl/AABUYvudo25UbW4gcD9FISBFa?dl=0

syl77 wrote: »

That's an old setup/heli... Im thinking around 300-350....
Probably a lot less than what you paid for it..

When you say old, do you mean the way the ball link linkage rods are done on the head? Or is there something else?

And the lack of a torque tube (is that the correct word?)

Thanks.