Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.

Seal between fireplace and stud partition

  • 19-11-2013 05:30PM
    #1
    TonyToo
    Registered Users, Registered Users 2 Posts: 4 ✭


    Hi,

    A number of years ago I got some renovation done in my old house and got a new fireplace put in. I also got a stud partition on the wall where the fireplace sits. Since then I have been using an electric heater in the room. However now I was wondering can I get an open fire again. There is a gap between the fireplace and the wall behind it where I can see insulation.

    The gap is in the fireplace opening, not around the outside or on the mantle.

    Is it possible to get that gap sealed so I could then begin using the fire again?
    Or because there is a stud partition in front of that wall not, would I never be able to use the open fire again?

    Thanks,

    Tony
    Tagged:


Comments

  • #2
    fredgalway
    Registered Users, Registered Users 2 Posts: 25 ✭fredgalway


    Hi It would not be advisable to have open fire in this situation, not alone would there be a danger of fire there would be an even bigger danger of fumes. I think your insurance company would have serious issues with what you are proposing. If you are determined to have open fire please get expert to advise and supervise on all work.


  • #3
    TonyToo
    Registered Users, Registered Users 2 Posts: 4 ✭TonyToo


    I still haven't got around to doing anything about this. I am thinking about removing the insulation (not entirely sure why it's in there in the first place) and sealing the gap between stud partition and the chimney breast/brace with fire resistant cement, then getting a insert stove put in. My biggest concern is the stud partition getting too hot. all ideas/suggestions/advice welcome. I would be getting a professional to do the work...whenever I get around to it.


  • #4
    kellymick39
    Site Banned Posts: 180 ✭✭kellymick39


    Get a solid fuel stove instead.Having an open fire and having an open fire means that all your fuel,all your heat and all your money is going up and out the chimney.
    Solid fuel stove for the win here.


  • #5
    kellymick39
    Site Banned Posts: 180 ✭✭kellymick39


    You would also need fireproof plasterboard as a stove and liner will give off a serious amount of heat.A builders merchants or fireplace and stove shop will advize on exactly what you need.Speak to Heating Distributors,Larmartine Fireplaces or Clifford Fireplaces and they will advize you best on what to do.


  • #6
    TonyToo
    Registered Users, Registered Users 2 Posts: 4 ✭TonyToo


    Finally saved up and got around to getting this completed.
    Ended up getting plumber and fireplace company out to do the job.
    got a stovax inset/insert stove installed with back boiler.
    They removed the old insulation and replaced it with fire resistant stuff.
    Lit a few small fires so far and all going well :-)


  • Advertisement
Advertisement