Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.

Eircom efibre F1000 port forwarding

  • 02-12-2013 09:46PM
    #1
    stephen73
    Registered Users, Registered Users 2 Posts: 2 ✭


    Has anyone got port forwarding working on the f1000?

    I got efibre installed last week but cannot get port forwarding working.

    I have searched the web but can't find a step by step guide that ensures that I have configured every section necessary. Anyone willing to help those of us less technically blessed with a walk through?

    Thanks!!
    Tagged:


Comments

  • #2
    madrabui
    Registered Users, Registered Users 2 Posts: 423 ✭✭madrabui


    Access your router F1000 web based console > Network Settings > NAT > Port Forwarding
    Check the Active checkbox, Choose VDSL, leave WAN IP blank, enter Trigger Start Port & End Port (can be same too). Same port nos. for Translation Start & End ports respectively. Server IP = local IP addr. of the system that needs to be accessible externally. Finally, I chose TCP/UDP & click OK.

    Hope it helps.


  • #3
    TheBoffin
    Registered Users, Registered Users 2 Posts: 434 ✭✭TheBoffin


    See this, page 154


  • #4
    stephen73
    Registered Users, Registered Users 2 Posts: 2 ✭stephen73


    Thanks Guys

    Really appreciate that you took the time to respond.

    I'm now up and running.

    Cheers!


  • #5
    jhconnolly
    Registered Users, Registered Users 2 Posts: 12 ✭jhconnolly


    Hi,

    I just got an Eircom F1000 efibre modem last week. I have been trying to port forward port 10000. I followed the exact procedure as above but it will not work. Does yours still work ? Maybe I have a different firmware rev.
    I have 1.00(AAHA.4)D0_20140623

    Thanks
    James


  • #6
    ainiseoir
    Registered Users, Registered Users 2 Posts: 292 ✭✭ainiseoir


    madrabui wrote: »
    Access your router F1000 web based console > Network Settings > NAT > Port Forwarding
    Check the Active checkbox, Choose VDSL, leave WAN IP blank, enter Trigger Start Port & End Port (can be same too). Same port nos. for Translation Start & End ports respectively. Server IP = local IP addr. of the system that needs to be accessible externally. Finally, I chose TCP/UDP & click OK.

    Hope it helps.
    I hope this gets to you after all this time.
    I have followed your instructions carefully, but though the new "rule" appears on the NAT screen with the yellow bulb when I go to the Server (On a Raspberry Pi) to check the Internet Connection on the server I get "Fail" and redirected back to the router .
    I'm doing this with the Router's firewall down as low as it will go.
    Any suggestion of what else I might do?
    Thanks


  • Advertisement
Advertisement