Push/Pull and a lace sensor dually bridge HB question?

seachto7 · 06-11-2013 01:50PM #1

Hi all,

About to mod a guitar, and going to stick a lace sensor dually red in the bridge.

However, when it comes to ordering the push/pull pot, what should I be ordering, or what should I be looking at?
A volume pot? Or just a pot? Not too sure...

wild turkey · 06-11-2013 07:18PM

Something like this

http://www.axesrus.co.uk/Medium-Shaft-PushPush-Alpha-Pots-p/medpushpushalpha.htm

250k for single coils 500k for humbuckers

Linear (

for volume pot
Log ( A )for tone pot although some guitars just use Log pots
Also check shaft length for the specific guitar

seachto7 · 06-11-2013 07:32PM

I'm going to be using it on a telecaster bridge humbucker. Should I get the 500K pot? I think it's in the volume pot on a tele but not too sure...

wild turkey · 06-11-2013 09:12PM

500k would be fine in there.
A lot depends on how bright the pickup is
EG; I always find Duncan JB sounds better with 250k pots, less harsh.

For the sake of a few quid I would get one of each & see which you like best.

seachto7 · 07-11-2013 12:16AM

Why would it be the volume over the tone pot though? (or vice versa)

wild turkey · 07-11-2013 06:08AM

You can do either,
tone pot would probably be easiest to operate

seachto7 · 08-11-2013 06:49PM

What would the difference be if it were in tone or volume, or does it matter?

wild turkey · 08-11-2013 09:26PM

Absolutely no difference

While the pot & dpdt switch are one piece they are completely independent of each other so where you use it doesn't matter

Personally I would put it on the tone pot because its the easiest to access & operate without interfering with anything else

Push/Pull and a lace sensor dually bridge HB question?

Comments