Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Force calculations for channel iron

  • 30-10-2013 08:55PM
    #1
    Milton09
    Registered Users, Registered Users 2 Posts: 453 ✭✭


    Folks,
    Can anybody tell me what force the channel section shown could take before breaking or bending past its yield point.

    1m6i.png
    Uploaded with ImageShack.us

    The ends are welded fixed and the bending force is applied through a welded bracket in the middle.
    Assume that the welds wont break and dont weaken the channel.

    Channel section is 76mm x 38mm and length is 1240mm
    Thanks


Comments

Advertisement