Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Original X360 HDD Case - What size are the T6 screws for the case?

  • 08-10-2012 07:56AM
    #1
    Junsuina Chikara
    Registered Users, Registered Users 2 Posts: 195 ✭✭


    Hi all. I have stripped the head removing the T6 screws that hold the hard drive case onto the hard drive. Two of the screws are ok and the other two seem a bit off. Although I have 2 screws holding at each corner, I still would like to have a set of 4 screws holding the case together and for the next time, I'll be more careful removing/replacing the screws to avoid this issue in future. The reason why I was opening the case is because I'm planning on upgrading the HDD to a larger one. So would anyone know the exact measurements of these screws? I know they're T6 screws but eBay brings about a whole range of different T6 screws. Thanks.


Comments

  • #2
    TouchingVirus
    Registered Users, Registered Users 2 Posts: 8,581 ✭✭✭TouchingVirus


    The hard drive screws are a T6. Length to bottom of the screw is 10mm, pitch is roughly 0.66mm between rings and diameter is 1mm.

    Best of luck finding replacements, it could be easier to order a replacement caddy off ebay/dealextreme


  • #3
    Junsuina Chikara
    Registered Users, Registered Users 2 Posts: 195 ✭✭Junsuina Chikara


    Thanks TouchingVirus. I can't find t6 m1x10 screws but I did find these so would they do? thanks.


Advertisement