Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

CAD geometry question

  • 20-08-2012 01:26PM
    #1
    breadmonkey
    Registered Users, Registered Users 2 Posts: 3,608 ✭✭✭


    Folks,

    I need to draw a line of fixed length from a fixed point on a horizontal line to the tangent of a circle. Anyone know if I can do this in CAD?

    [IMG][/img]cadl.jpg


Comments

  • #2
    CatFromHue
    Moderators, Science, Health & Environment Moderators Posts: 18,474 Mod ✭✭✭✭CatFromHue


    What program are you using?


  • #3
    CatFromHue
    Moderators, Science, Health & Environment Moderators Posts: 18,474 Mod ✭✭✭✭CatFromHue


    swsketch.png


    On the left half the line does not have a tangent constraint to the circle so you can put in the length of the line.

    On the right half the line does have a tangent constraint to the circle so can't put in a length for the line.

    This is on Solidworks


  • #4
    chris85
    Registered Users, Registered Users 2 Posts: 4,502 ✭✭✭chris85


    I think you need to remove the constraint from the centre of the circle to the end of the line, or remove the constraint from the end of the line to the horizontal axis of the circle. With both of these in place you will not be able to get a tangent and fixed length as no freedom of the point at end of line to move.

    If one of these is removed than you should be able to tangent and get a fixed length on it. Thats how I see it anyways.


  • #5
    Turbulent Bill
    Registered Users, Registered Users 2, Paid Member Posts: 1,647 ✭✭✭Turbulent Bill


    breadmonkey wrote: »
    Folks,

    I need to draw a line of fixed length from a fixed point on a horizontal line to the tangent of a circle. Anyone know if I can do this in CAD?

    It's not possible exactly as you've drawn it, as the centre of the circle is at the origin. If both points "a" and "b" of the line are fixed (defining both the line length and its position), then the circle centre and radius can't be constrained if the line is to be tangent. Similarly, if only "a" and the line length are fixed (i.e., line free to rotate around "a"), then the circle centre can be on the origin with just its radius unconstrained.

    Note that this is a fundamental geometric restraint, not a CAD one. Any CAD program worth its salt will flag errors if you try to over-constrain geometry.


Advertisement