[Tutorial] Using a Nand-X to flash your Coolrunner Board

You can flash your coolrunner glitch boards using a Nand-X that has been previously updated to the ARM code included with Nandpro v3.0. If you need a guide about how to do that (using a CK3 Pro/CK3i) then look here.

Once again, TX have a cable that hooks up to your expansion slot (the 50-pin wide slot on the Nand-X) and connects to the coolrunner JTAG port but I'm fed up waiting for UK suppliers to get stock so I made my own DIY solution that'll do until they get stock and I buy one

Firstly you should apply flux and some spare solder to the pins on the coolrunner.I didn't want to put excess solder on the actual connector end of the pin because in the future the JTAG cable mighn't fit if I need to update the coolrunner code So I applied the flux & spare solder down where the pins meet the board



Next I hooked up six wires to the expansion port. This is some small soldering with the risk of melting a little plastic on the port but it seemed to be resistant enough to short bursts of contact so I didn't inhale any toxic fumes :P. You need to solder wires to Pins 1, 24, 25, 26, 28 and 49. All the odd numbered pins are at the back of the port, starting on the right with number one. All the even numbered pins are at the front starting on the right with number 2.





Now to join the wires from the Nand-X to the Coolrunner:

Nand-X | Connects To | Coolrunner
1 | | GND
24 | | TDO
25 | | TCK
26 | | TDI
28 | | TMS
49 | | 3.3V




Flick the switch on your coolrunner board so it's set to PRG (Program) and then put the USB cable into the Nand X.




Use Nandpro to write the XSVF file for the console that you're using the Coolrunner board with. The XSVF files are attached to this post.



And that's it. Go install the coolrunner board