Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

IMAX B6 Chaarger (INPUT VOL ERR)

  • 04-07-2011 10:50AM
    #1
    SickMusicMan
    Registered Users, Registered Users 2 Posts: 121 ✭✭


    Hey everyone.

    I hope someone can help me with an issue I'm having with my new IMAX B6 Balance Charger. Every time i plug the charger into a mains power supply or a car battery I keep getting the same input voltage error message and a really annoying beeping noise :mad:. If i try to go and change the battery settings the error comes on again :confused:. It wont allow me to go into any of the setting screens.

    Has anybody else had the same problem?

    Regards,

    Liam.


Comments

  • #2
    goblin59
    Registered Users, Registered Users 2 Posts: 1,954 ✭✭✭goblin59


    i had the same problem., seem to fix it by changing the charge rating to 0.4a when choosing the settings.


  • #3
    SickMusicMan
    Registered Users, Registered Users 2 Posts: 121 ✭✭SickMusicMan


    Cheers for the reply goblin59, but every time i try to change the settings, it starts beeping at me and showing the same fault message :(.
    It wont let me change anything.


  • #4
    goblin59
    Registered Users, Registered Users 2 Posts: 1,954 ✭✭✭goblin59


    it should give you the option to change it by just clicking enter once, then amps will start flashing, use up and down to change that, then once it is set hold in enter untill it starts the charging sequence


  • #5
    SickMusicMan
    Registered Users, Registered Users 2 Posts: 121 ✭✭SickMusicMan


    I had to get it replaced in the end, but cheers for the advise and help ;)


Advertisement