How to use my Mackie Onyx in Cubase

white_falcon · 20-05-2008 02:51PM #1

So I finally fixed a problem with the firewire on my PC and want to try and record with my Mackie Onyx Satellite. However, the manual for the Mackie doesnt show how to use it with cubase.

How do you normally use an audio interface with Cubase?

white_falcon · 20-05-2008 06:57PM

Even if someone could just tell me how to use an audio interface in cubase usually - as in how do you set them up it would be handy thanks

ogy · 20-05-2008 09:56PM

Devices -> Device Setup -> VST Audiobay -> Master ASIO Driver drop down -> select the driver for the onyx.

hope that helps:)

white_falcon · 20-05-2008 10:01PM

ogy wrote: »

Devices -> Device Setup -> VST Audiobay -> Master ASIO Driver drop down -> select the driver for the onyx.

hope that helps:)

yea thanks

i think theres more to it than that, because i create an audio track with the onyx driver set up correctly and all, and the only in and out it gives me are Virus ASIO in, and Virus ASIO out - Virus Ti keyboard im using..

Ah well..more fiddling about to be done i suppose

ogy · 20-05-2008 10:23PM

ok that sound like you have no busses set up so:

Devices -> VST Connections -> Inputs Tab -> Add Bus -> Stereo x 1 -> Click on the corresponding left and right inputs under device ports and there should be options for your mackie inputs there -> do the same thing under outputs

if the mackie ins and outs aren't listed the driver isn't working properly

How to use my Mackie Onyx in Cubase

Comments