Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Eircoms Netopia Firmware Upgrade Breaks NAT!

  • 23-07-2005 04:17PM
    #1
    r00t69
    Registered Users, Registered Users 2 Posts: 144 ✭✭


    Before I upgraded to their latest FW I had eMule playing nice and always getting a HighID. Now its always a LowID. Tried using the built in profile and creating a seperate profile.

    Have the Eircom Modem connected to a LinkSys router so the LAN hangs of the Linksys which routes to the modem on a seperate subnet.

    Played nice until the upgrade. Anybody else have this problem?


Comments

  • #2
    Red Alert
    Hosted Moderators Posts: 7,486 ✭✭✭Red Alert


    Find out the e-mule ports, and port forward on BOTH the nettopia and the linksys to your own PC.

    You can probably change the routing/gateway option on the Linksys so that NAT only gets done once by the Eircom one.


  • #3
    r00t69
    Registered Users, Registered Users 2 Posts: 144 ✭✭r00t69


    Red Alert wrote:
    Find out the e-mule ports, and port forward on BOTH the nettopia and the linksys to your own PC.

    You can probably change the routing/gateway option on the Linksys so that NAT only gets done once by the Eircom one.

    Thanks Red Alert. Essentially as the router is the only item in the Subnet where the Modem resides the pin holes have been set up on the modem for that router. I have then opened up the ports on the router for the specific IP Addy on the LAN. However the point is the only thing that has changed in the setup is the new Firmware for the Modem. Since that upgrade NAT seems not to work!


Advertisement
Advertisement