Bike stand repair: drilling out a broken stud

The classic way is this but it involves welding.

https://www.youtube.com/shorts/XODPhxEMCzw

The other way is with an extractor

https://www.youtube.com/shorts/11dk3hJaHq8

Just beware cheap extractors may do the job but they are very prone to snap.

The cheap stuff will do the job but the user has to know when to stop applying pressure.

This set goes small enough for you but its the small extractors I've snapped in the past.

https://www.amazon.co.uk/HSEAMALL-Extractors-Damaged-Extractor-Combination/dp/B08JPF5G99/

Cheaper sets won't be any worse.

Some good info from my favourite Youtube channel

Is it in tight? As in you snapped the head off taking out or putting it in?

There's always the possibility of using a disc in a Dremel to cut a slot and use a flat screwdriver if its not really tight.

Ideally you want about a mm sticking out to successfully put a slot in it. If there is anything at all sticking out then mole grips might get a hold on it. Not a job I think I'd go an buy a Dremel for, just worth a go if you had one. New stand might be cheaper than the Dremel.

Easy out the best method. The TopTul ones are around €12 for a pack of 5. Have them and sliverline which were slightly cheaper and was a pack of 7 and can see no difference in quality.

Its very satisfying when done correctly