Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

HKC Reed Sensor Question

  • 15-05-2021 02:20PM
    #1
    cubix
    Registered Users, Registered Users 2 Posts: 2,166 ✭✭✭


    Hoping someone can point me in the right direction. The cover of the old sensor finanaly gave up the ghost and I am now getting an open zone on this unit. Thought I would get away with just replaceing the cover but newer unit is smaller. Can any tell me what goes where please.

    Old unit:
    Black is -12V
    Red is +12V
    Yellow is data
    Blue is unused
    Tappper is bridged

    New Unit
    Middle two scews are tapper
    Next pair of screws are sensor but done see any + or-
    Out pair are marked Reed/Spare


Comments

  • #2
    kub
    Registered Users, Registered Users 2 Posts: 6,595 ✭✭✭kub


    cubix wrote: »
    Hoping someone can point me in the right direction. The cover of the old sensor finanaly gave up the ghost and I am now getting an open zone on this unit. Thought I would get away with just replaceing the cover but newer unit is smaller. Can any tell me what goes where please.

    Old unit:
    Black is -12V
    Red is +12V
    Yellow is data
    Blue is unused
    Tappper is bridged

    New Unit
    Middle two scews are tapper
    Next pair of screws are sensor but done see any + or-
    Out pair are marked Reed/Spare




    Your new sensor is the wrong model, you should have gotten a Point ID Reed Sensor.


  • #3
    altor
    Registered Users, Registered Users 2 Posts: 12,094 ✭✭✭✭altor


    You will need engineer access to delete the old ID sensor and add a new one.

    www.altor.ie



Advertisement
Advertisement