Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

SPC5300 Battery Low

  • 22-07-2020 02:44PM
    #1
    fergalom
    Registered Users, Registered Users 2 Posts: 115 ✭✭


    SPC 5300 panel is showing a "battery low" message on kepad.

    Loggin into panel and extract below is from the status info page:

    Power
    Mains: OK
    Mains time sync.: OK (50Hz)
    Battery: Fault
    Battery Voltage: N/A
    Battery Current: N/A
    Aux. Voltage: 13.2V
    Aux. Current: 100mA
    Aux. Fuse: OK
    Ext.Bell Fuse: OK
    Int. Bell Fuse: OK


    Its been in a number of years (diy install) so is it feasible it would just need replacing or likely a loose connection?

    Asking first as panel is not in the most accessible locations.


Comments

  • #2
    altor
    Registered Users, Registered Users 2 Posts: 12,049 ✭✭✭✭altor


    fergalom wrote: »
    SPC 5300 panel is showing a "battery low" message on kepad.

    Loggin into panel and extract below is from the status info page:

    Power
    Mains: OK
    Mains time sync.: OK (50Hz)
    Battery: Fault
    Battery Voltage: N/A
    Battery Current: N/A
    Aux. Voltage: 13.2V
    Aux. Current: 100mA
    Aux. Fuse: OK
    Ext.Bell Fuse: OK
    Int. Bell Fuse: OK


    Its been in a number of years (diy install) so is it feasible it would just need replacing or likely a loose connection?

    Asking first as panel is not in the most accessible locations.

    Have you replaced the back up battery?

    www.altor.ie



Advertisement