HKC inertia sensor with Reed on a 4 wire cable?

Shed. · 12-09-2017 10:42PM #1

Is this possible. There are 2 terminals for tamper 2 for sensor and 2 for Reed.

Thanks.

Shed. · 12-09-2017 10:47PM

Shed. wrote: »

Is this possible. There are 2 terminals for tamper 2 for sensor and 2 for Reed.

Thanks.

Suppose it could be if I didn't have a tamper circuit... ðŸ€”

davehogan100 · 12-09-2017 11:46PM

Is it just one sensor or multiple sensors?

KoolKid · 13-09-2017 06:07AM

The sensor and reed are wired in series on one pair and the tamper is on a separate pair. If you want the reed and sensor on separate zones you could use duel resistors. This would give you sensor and tamper on one pair and reed on another pair.

Shed. · 19-10-2017 03:03PM

KoolKid wrote: »

The sensor and reed are wired in series on one pair and the tamper is on a separate pair. If you want the reed and sensor on separate zones you could use duel resistors. This would give you sensor and tamper on one pair and reed on another pair.

Thanks for that.

KoolKid · 19-10-2017 06:47PM

Your welcome. Did it all work out for you.?

altor · 20-10-2017 09:26PM

Shed. wrote: »

Suppose it could be if I didn't have a tamper circuit... &#55356;&#56340;

You could also have it on two zones using the 4 core cable.
Dual the contact with tamper and put the shock on another zone.

HKC inertia sensor with Reed on a 4 wire cable?

Comments