Any idea what is causing this water on the floor?

Blub123

So went into utility room this morning and no problem. 1 hr later went in and found a pool of water on the floor.

As you can see from the pics, condensation on the tank.

Tank felt cool to the touch at the bottom but warmer further up.

In terms of activity there were 2 showers taken in between both times.

I can't see any discernable leak from any of the pipes etc.

There is a dryer in the room but it's a condensing drier so don't think it's moisture in the air etc and too much water on the floor to point to this.

Pictures of tank, fllor etc attached.

Any ideas?.... Many thanks

IMG-20250408-WA0001.jpg

IMG_20250408_193610.jpg

IMG_20250408_193602.jpg

IMG-20250408-WA0000.jpg

10-10-20

I think that's splashing and not condensation. Best dry it off now and check again tomorrow.

Blub123

Splashing from what / where? Thanks

Hobby farmer

Is there a pressure gauge there? Where does the pressure relief valve terminate? Take a picture of the full tank

10-10-20

https://www.boards.ie/discussion/comment/123339496#Comment_123339496

...and piping to the right of it.

Blub123

See further photo... Leak is appearing 180 degrees directly behind the X and not out of the release valve.

Did not occur today so am stumped.!

Hobby farmer

Without seeing your specific setup, my guess is the prv opened due to high pressure.

Blub123

https://www.boards.ie/discussion/comment/123342794#Comment_123342794

Thanks, yes that was my thoughts to begin with however no water appearing whatsoever where the prv is.