Self install Harvi and CT clamp to add missing "consumed" data on MyEnergi?

tandcapply

Hi,
Have had Solar installe last year, installer set up a cable but only installed one CT clamp into the Hub.
I was hoping to get someone to simply use the same RJ-45 and connect a second CT clamp to read the missing Consumed data to get ful lpiscture on the MyEnergi app.

I've the v2 Eddi with a relay so in theory could get a sparky to connect the 2nd CT clamp that I already bought (assuming they won't hang up the phone when hearing about such a small job).

Other option would be to self install the Harvi using that 2nd CT clamp if possible.

I'm nt planning on wiring anything myself, just putting the CT clamp around the power cable in the consumer unit.
did anyone do something like that themselves?

TIA

slave1

The installer should have clamped your mains feed at the consumer unit and fed this to the Zappi. This will show you consumed electricity and is required for load balancing your Zappi.

By the looks of your wording this was not done, what can you see on the App? Preferably a screenprint.

tandcapply

https://www.boards.ie/discussion/comment/122401683#Comment_122401683

@slave1 i should have clarified, I have no Zappi, nor battery at present it's just Eddi which seems to report fine.but can only see exported in the MyEnergi app.

the green shows as 0 all the time