Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Cutting height from internal doors

  • 05-06-2024 10:58am
    #1
    Posts: 4,149 ✭✭✭ Bruno Little Pail


    Hi All,

    I bought the below doors to replace my existing. I bought the size closest to my existing frames. The width is fine, I might have to shave a small bit off but the height I may need to take 20mm off.

    Every YouTube video I have watched says you always cut off the bottom when adjusting for height but the issue is that this door says it has 11mm lippage all the way around.

    It's a solid core door but I assume it's MDF inside once you get past the lippage..

    Whats best practice here, cut 10mm off the top and bottom or just take the 20mm off the bottom because it won't be seen?

    Thanks

    https://murphylarkin.com/NM5-Primed-Internal-Door



Comments

  • Registered Users, Registered Users 2 Posts: 31,232 ✭✭✭✭Lumen


    20mm off the bottom because it won't be seen?

    Surely it will be seen because the shaker panels will be different heights top and bottom.

    I've only hung a couple of doors but I'd be inclined to cut top and bottom to keep it symmetrical.



  • Registered Users, Registered Users 2 Posts: 2,888 ✭✭✭Hooked


    I'd go top and bottom - skill saw (with makeshift guide) or plunge saw on a rail if you can.

    Panels top/bottom will be even and you won't compromise the door.

    You could first drill a pilot hole with a small bit to gauge the depth/solid portion.



  • Posts: 4,149 ✭✭✭ Bruno Little Pail


    The shaker panels are always different sizes, the bottom is always bigger than the top unless you chopped 3 inches off it, the reason is depth perception, same as why the hinges top and bottom of a door are different heights.

    I am actually going to call them tomorrow because the doors arrived now and to me they look completely solid and the packaging makes no reference to lipping like that website I referenced does



Advertisement