How to remove this shower head? It just rotates on both sides

Roberto_gas

Looking for some guidance on how to remove this showerhead. The plastic part just rotates. There is a hole on the top but its tiny. Is that a clip push something?

Sleeper12

Most likely inside the tiny hole is a grub screw. Most likely a small allen key is needed.

Roberto_gas

https://www.boards.ie/discussion/comment/122084086#Comment_122084086

No grub screw unfortunately….checked it. There is just some flat plastic behind that hole.

Sleeper12

I'm not familiar with this head. I wonder if the flat plastic inside the hole should be pushed in with a small screwdriver. The head itself that you already removed looks like a mira head. Maybe Google mira fixed head

hongler

Seems like a Mira

https://www.bathroomsandshowersdirect.co.uk/shower-heads/shower-heads/mira-41192-adjustable-shower-head

Sleeper12

This is you shower. It's a Mira Response

Roberto_gas

https://www.boards.ie/discussion/comment/122085304#Comment_122085304

legend thanks ! so top and bottom cover just pull off ??

magicbastarder

Looking at that, I'd say the top half of the cover is screwed on but the bottom half clips on?

magicbastarder

although on yours - that seems to be all one piece rather than in two halves?

edit: yours appears to be an RF7 model from what i can see?

https://www.showerspares.com/mira_shower_spares/mira_all/mira-response-rf7-bir-fixed-shower-head-white-1605.129/

Roberto_gas

https://www.boards.ie/discussion/comment/122085608#Comment_122085608

sounds right…how do i get rid of the plastic bracket ?

Roberto_gas

https://www.boards.ie/discussion/comment/122085514#Comment_122085514

its a single unit

standardg60

https://www.boards.ie/discussion/comment/122085858#Comment_122085858

You can send them a question in that link.

I would try inserting a flat head screwdriver into the hole and pulling at the same too.

Roberto_gas

success looks like it had to be twisted to release..but the installer never put the two screws so entire assembly was turning !!

Do i need to remove the rest of the parts as well to put a new head or just use this extension? How deep will this go in the wall?

Roberto_gas

folks have managed to removed everything..is this pipe at the end also removable? If yes do i just twist it anti-clockwise using a wrench? Thanks a mill