Small metal part needed

Con Connor

Hi, first post here looking for a member with a milling machine who can made a replacement part for an discontinued item. Its a brake disk off a ride on mower. The guy who removed this disk was trying to free up a seized brake caliper so I could use the brake to stop the mower from crashing... Its OD is 50mm (ignore the read out in the pic) I have a CAD file and the damaged part - can anyone on boards.ie make one of these for me? Regards Con

T5180

You could check in E. Fox Engineering Catalogue for a motor drive coupling with the same bore and keyway and then machine off the excess material on a lathe . it might be quicker than starting from scratch.

Con Connor

https://www.boards.ie/discussion/comment/121333428#Comment_121333428

Hi T5180, thanks for the suggestion but I do not have a lathe or the skills to use one - I'm looking to pay a skilled craftworker to make one for me - can pay cash...

T5180

If you can send me some dimensions and are not in a hurry I can probably help . Drop me a PM .

Con Connor

Hi T5180,

I have a CAD file that I tried to attach here but I got this reply.

I've added the CAD file as a zip - unsure if this will work.....

Can I send the CAD file to you by email?

Regards

Con

mower bracket.stp(1).zip

Con Connor

https://www.boards.ie/discussion/comment/121347442#Comment_121347442

the reply I mentioned disappeared when I sent my last comment... I'm new to boards...

T5180

file received , i will see if i can open it tomorrow

Con Connor

https://www.boards.ie/discussion/comment/121364007#Comment_121364007

Great - chat later