Skip to content
  • Register
    • Advertisement
    If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
    Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

    Troubleshooting: Beading during print

    • 01-11-2023 06:00PM
      #1
      [Deleted User]
      Posts: 0
      ✭


      IMG_20231101_145537.jpg

      I've swapped filament, changed out extruder arm/gears, different bed, cleaned nozzel, and using files I've orinted many times before.


      Any ideas what causes this?

      Hope some of the old posters still keep an eye on this forum



    Welcome!

    It looks like you're new here. Sign in or register to get started.
    Sign In
    Register

    Comments

    • #2
      banie01
      Registered Users, Registered Users 2 Posts: 17,842 banie01
      ✭✭✭✭


      2 things that spring to mind. 1. Is there any possibility the filament may have absorbed some humidity? 2. Have you set the flow rate/E-steps?



    • #3
      [Deleted User]
      Posts: 0 [Deleted User]
      ✭


      https://www.boards.ie/discussion/comment/121313523#Comment_121313523

      Yeah thought of the humidity angle too. Swapped out filaments.


      I had everything set perfectly for the files I was reprinting but, yeah, tried to tweak settings to no avail



    • #4
      AirBiscuit
      Registered Users, Registered Users 2 Posts: 1,064 AirBiscuit
      ✭✭✭


      It's not extruding enough plastic. You might have a partial clog in the nozzle, see if doing a cold pull fixes the issue



    Welcome!

    It looks like you're new here. Sign in or register to get started.
    Sign In
    Register
    Advertisement