Do these Parts work together and why do they not work for me :(

omega42

So I decided to build a new PC and I think!!! they all should work together.

https://www.amd.com/en/products/cpu/amd-ryzen-7-2700

Aerocool Integrator 600 W 80 Plus Bronze Power Supply Unit with UK 3 Pin Power Lead

CORSAIR CMK32GX4M2E3200C16 VENGEANCE LPX 32GB (2 x 16GB) DDR4 3200 (PC4-25600) C16 1.35V Desktop Memory - Black

https://rog.asus.com/motherboards/rog-strix/rog-strix-b450-f-gaming-ii-model/

I have a graphics card but I'm trying to get it up and running on the onboard graphics. (but have tried with graphics card in, no difference)

The Problem is when I plug in the monitor and switch it on. I'm just getting a black screen, there is a signal getting to the tv as it goes from bluescreen to black but no graphics. it doesn't even load the BIOS. with my limited computer knowledge I'm guessing its the MB but would like your opinion

What I've Tried

checked the ram by cleaning and then trying each stick separate.

Replaces the CPU with an older one to see if the bios needed flashing for the newer chip

checked a different power supply

As always

TIA

Mr. CooL ICE

Shot in the dark here, but I once had a problem with the reset switch on the case. I unplugged that from the section where the case's front panel connects to the motherboard and it worked fine.

Failing that, just verify the front panel connections are correct and PSU to motherboard connectors are all secure

dazberry

BTW: "Onboard" graphics for the Ryzen series of processors only work with the G series of (APU) chips, 2200g, 5600g etc. - there's no "onboard" graphics in the classic sense on the motherboards like there used to be. So no point trying to setup without a separate graphics card.

K.O.Kiki

Ryzen 2700 does not have onboard graphics.

Can you confirm you plugged the display cable into the graphics card and NOT the motherboard?

omega42

Yeah, tried it with and without graphics card

omega42

K.O.Kiki

https://www.boards.ie/discussion/comment/118566618#Comment_118566618

The Ryzen 2700 does not have onboard graphics.

You literally cannot get a video signal without a graphics card installed.

Skerries

I had this problem before and it was that the HDMI wasn't working but would work with the DP cable into the GPU

what GPU is it?

omega42

https://www.boards.ie/discussion/comment/118570736#Comment_118570736

Evga gtx 1060 sc 6GB

Hyzepher

Firstly makes sure you have the monitor plugged into the 1060 and not the motherboard.

Next, that motherboard would most definately been configured for Ryzen 3xxx and 5xxx processors. You will need to down step the bios. That board comes with a flashback option so you should be able to do it with the 2700 installed. Just follow the instructions on the Asus support site