Hikvision Notification Arming Schedule

DaveyDave

Recently setup a bunch of different alerts on my cameras but the arming schedule doesn't seem to be setup correctly.

I have it set from 00:00-06:00 but it seems to go off all day. Week is set to Monday, do I need to pick every day and set a time?

The line crossing detection went off as a delivery driver was walking back to his van earlier and I had to turn off boundary crossing in the back garden due to birds.

Any ideas? 7604 NVR.

altor

DaveyDave wrote: »

Recently setup a bunch of different alerts on my cameras but the arming schedule doesn't seem to be setup correctly.

I have it set from 00:00-06:00 but it seems to go off all day. Week is set to Monday, do I need to pick every day and set a time?

The line crossing detection went off as a delivery driver was walking back to his van earlier and I had to turn off boundary crossing in the back garden due to birds.

Any ideas? 7604 NVR.

Yes there should be an arming schedule for each day.
Sensitivity settings are a pain setting it up, car lights set it off also, environmental movement also.
You can set directional setting to catch some one coming onto the property

DaveyDave

altor wrote: »

Yes there should be an arming schedule for each day.
Sensitivity settings are a pain setting it up, car lights set it off also, environmental movement also.
You can set directional setting to catch some one coming onto the property

I had a feeling, haven't had a chance to change the settings until now so I'll go through it all again.

The line crossing went off from a cars headlights across the road the other day and the apartments are busy enough so I'll probably be tweaking the sensitivity. I just hope there isn't too much activity that prevents the line crossing working as intended.

altor

DaveyDave wrote: »

I had a feeling, haven't had a chance to change the settings until now so I'll go through it all again.

The line crossing went off from a cars headlights across the road the other day and the apartments are busy enough so I'll probably be tweaking the sensitivity. I just hope there isn't too much activity that prevents the line crossing working as intended.

I've tried loads of different setting and the lights at night set it off no matter what.

DaveyDave

In the last two days or so I've had random intrusion detection alerts at the front of the house. I suspect this may be from shrubs blowing in the wind. I might be better off adding line crossing instead if that's the case.

Strangely enough, there's no motion recorded and the notification playback says failed to play video: Error Code 380070. Must have a mess around with the settings.

Also the back camera intrusion detection goes off when the kitchen light is on as it lights up the garden with the blinds closed...

altor

DaveyDave wrote: »

In the last two days or so I've had random intrusion detection alerts at the front of the house. I suspect this may be from shrubs blowing in the wind. I might be better off adding line crossing instead if that's the case.

Strangely enough, there's no motion recorded and the notification playback says failed to play video: Error Code 380070. Must have a mess around with the settings.

Also the back camera intrusion detection goes off when the kitchen light is on as it lights up the garden with the blinds closed...

Environment Movement is always an issue.
Play around with sensitivity settings to see if this helps.

machiavellianme

Or use Intrusion detection. Set the area to be slightly smaller than the region of interest so that branches or shrubs don't blow in randomly. Also set it to have an intrusion of at least 1 second in the area. That way, insects flying close to the camera won't trigger it as they dash across it quickly, but it'll be long enough to capture any people walking across.