Shooting Forum - Firearms licencing information

Johnner2 · 2021-01-01 09:14:52

Bit of shed time a couple of days back, I made up this swinging plinking target out of a few bits and pieces I had lying around, I got 2 round plasma cut 13mm x90mm plate a couple of months back from a scrap bin, I should have took some more. Anyway this turned out OK, no welder this time I decided to bolt the pendulum arm…

Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.

https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.

DIY pinking target

01-01-2021 10:14AM

#1

Johnner2

Registered Users, Registered Users 2 Posts: 49 ✭

Join Date: December 2020

Posts: 41

Bit of shed time a couple of days back, I made up this swinging plinking target out of a few bits and pieces I had lying around, I got 2 round plasma cut 13mm x90mm plate a couple of months back from a scrap bin, I should have took some more. Anyway this turned out OK, no welder this time I decided to bolt the pendulum arm onto the plate using stainless steel bolt and nut, pendulum arm I twisted to reduce the chances of a bullet strike. Arm is stainless steel thin but strong.I'm happy enough with the outcome.

4