Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Inline Topper

  • 07-10-2020 9:02am
    #1
    feartuath
    Registered Users, Registered Users 2 Posts: 343 ✭✭


    Just picked up a Conor twin rotor topper with no Pto Shaft
    The shaft is a T50 with shear bolt and o/run clutch.

    Does anyone know what length these PTO work at.
    Local supplier has them in stock at 950mm compressed.


Comments

  • #2
    hopeso
    Registered Users, Registered Users 2 Posts: 1,458 ✭✭✭hopeso


    feartuath wrote: »
    Just picked up a Conor twin rotor topper with no Pto Shaft
    The shaft is a T50 with shear bolt and o/run clutch.

    Does anyone know what length these PTO work at.
    Local supplier has them in stock at 950mm compressed.

    As with any machine, the shaft will have to suit the distance between your tractor and the machine. For a rough idea, attach the topper to your tractor and measure the distance between both pto stubs. Take a measurement with the topper resting on the ground, and again with the topper fully raised. If in doubt, buy a shaft longer than you need, and cut it to suit. Be very careful not to fit a shaft that is too long, as it could cause major damage when you lift the machine. If cutting a shaft, take equal amounts off both tubes, and leave it as long as possible to work without closing fully when it’s at it’s shortest.


  • #3
    feartuath
    Registered Users, Registered Users 2 Posts: 343 ✭✭feartuath


    Thanks for the reply, I am away at present so cannot measure so wanted to order shaft this morning.


Advertisement