Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Planed Deanta Oak Door

  • 20-05-2020 8:33am
    #1
    eusap
    Registered Users, Registered Users 2 Posts: 667 ✭✭✭


    Hi, we got a Deanta Oak internal door installed and the edges where planed to fit the frame, can somebody recommend a product to to refinish the edge? Oil, varnish etc...


Comments

  • #2
    tabby aspreme
    Registered Users, Registered Users 2 Posts: 4,099 ✭✭✭tabby aspreme


    Cellulose lacquer, is the finish on most shop bought doors, most hardware/paint shops sell it in aerosol cans, which would be fine for what you need, you may need to mask the door faces, a few inches either side to avoid over spray.


  • #3
    kadman
    Moderators, Home & Garden Moderators Posts: 5,126 Mod ✭✭✭✭kadman


    Surely you should be contacting the manufacturer for this advice, so as not to affect the guarantee, if any,

    http://deantadoors.ie/


  • #4
    kadman
    Moderators, Home & Garden Moderators Posts: 5,126 Mod ✭✭✭✭kadman


    Problem with masking and overspray is the possibilty of a definitive raised edge where the two meet,

    if you are not carfeul. Then feathering off with wet and dry paper. So attention to the detail during the finishing.


  • #5
    eusap
    Registered Users, Registered Users 2 Posts: 667 ✭✭✭eusap


    i did contact Deanta and they sent this from there website "3 coats of internal wood finish are required on unfinished doors and on any modifications to a prefinished door including the ironmongery and hinge cut-outs" which didn't help which is why i asked for experience from here


  • #6
    kadman
    Moderators, Home & Garden Moderators Posts: 5,126 Mod ✭✭✭✭kadman


    eusap wrote: »
    i did contact Deanta and they sent this from there website "3 coats of internal wood finish are required on unfinished doors and on any modifications to a prefinished door including the ironmongery and hinge cut-outs" which didn't help which is why i asked for experience from here


    Brilliant, about as useful as a chocolate fireguard.

    You came to the right place so:)


  • Advertisement
Advertisement