Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.

HKC1070 to SABB

  • 29-03-2020 09:41PM
    #1
    med10n
    Registered Users, Registered Users 2 Posts: 6 ✭


    hello,
    would anyone know the reason for this ?. i'm connecting a SABB to a HKC1070 panel. On the SABB manual it says to connect the strobe terminals on the SABB to the Internal Bell terminals on the hkc1070 panel. On the HKC1070 manual, it says to connect the SABB strobe terminals to the strobe terminals on the panel. i assume both are correct but why the difference ?.

    thanks


Comments

  • #2
    altor
    Registered Users, Registered Users 2 Posts: 12,024 ✭✭✭✭altor


    med10n wrote: »
    hello,
    would anyone know the reason for this ?. i'm connecting a SABB to a HKC1070 panel. On the SABB manual it says to connect the strobe terminals on the SABB to the Internal Bell terminals on the hkc1070 panel. On the HKC1070 manual, it says to connect the SABB strobe terminals to the strobe terminals on the panel. i assume both are correct but why the difference ?.

    thanks

    The reason for this is to keep them separate, on the older 8/12 panel both where installed in the internal bell unless you used a separate output for the strobe.
    On the 1070 they added the extra output for this.

    www.altor.ie



  • #3
    med10n
    Registered Users, Registered Users 2 Posts: 6 ✭med10n


    many thanks Altor for the information,

    regards


Advertisement