Inkbird help

No really a brewing question but I know you guys use the inkbird controllers.

I have an Inkbird 1tc 308 in my greenhouse,
Im not sure it can do what I want it to do but here goes.
I want it to come on heat at 5c and not drop below 5c this bit I can do.

But I also want it cool above 20c using the fan.
At the moment it will take 5c as the target temp and once above 5c cooling mode kicks in .
Basically I'd like to set a range 5c-20c and not a target 5c.

I could fit another thermostat on the fan but I was hoping the inkbird could do it.

any advice welcome .

raxy

Should be able to do that. If you set your temperature to 12.5 degrees & the hd setting to 7.5.
Then when it gets below 5 it will heat & if it goes over 20 it will cool. What I'm not sure is when it will turn off. I think it will either heat or cool until it gets back to 12.5 degrees so may not be ideal.
Other than that I think your looking at a separate controller.

Thats Raxy,
I'm going to look into using 2 sonoff controllers instead.
one for heat and one for cooling.
Might just have to start brewing now!