Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

1988 JCB 3cx with crack in block, advice needed please

  • 22-08-2019 5:51pm
    #1
    samjames
    Registered Users, Registered Users 2 Posts: 213 ✭✭


    1988 jcb 3cx with crack in block,



    can this be welded suceessfully


Comments

  • #2
    stock>
    Registered Users, Registered Users 2 Posts: 755 ✭✭✭stock>


    Where is the crack located? might be better to do a temp repair with JBweld or such so as to make sure it not cracked internally or that the head is cracked.....................................................................
    Welding is possible...........................................


  • #3
    samjames
    Registered Users, Registered Users 2 Posts: 213 ✭✭samjames


    stock> wrote: »
    Where is the crack located? might be better to do a temp repair with JBweld or such so as to make sure it not cracked internally or that the head is cracked.....................................................................
    Welding is possible...........................................
    side of block, about 4 inches,
    would jb weld stay in it?


    to weld it properly would engine need to be took out


  • #4
    stock>
    Registered Users, Registered Users 2 Posts: 755 ✭✭✭stock>


    samjames wrote: »
    side of block, about 4 inches,
    would jb weld stay in it?

    to weld it properly would engine need to be took out
    Can you post a picture of it ?


  • #5
    9935452
    Registered Users, Registered Users 2 Posts: 2,835 ✭✭✭9935452


    samjames wrote: »
    stock> wrote: »
    Where is the crack located? might be better to do a temp repair with JBweld or such so as to make sure it not cracked internally or that the head is cracked.....................................................................
    Welding is possible...........................................
    side of block, about 4 inches,
    would jb weld stay in it?


    to weld it properly would engine need to be took out

    I was told at one stage that for a good strong weld it would have to be welded on the flat.
    I few older lads at home told me how they turned tractors on their side to weld the blocks . Easier than taking out the engine


Advertisement