Need to rewire

niftthelean

Hi,
I am living in a place I bought a few years back. House was build in 1988.

Fusebox though has the old 60A fuse, two of which have blown on me
(overloaded probably, always when the electric shower and plenty of other
appliances were in operation).

I decided to get it looked at. We want a few other minor electric jobs done
anyway. On inspection, the REC indicated that:
* I need a new fusebox - the circuit breakers are 'L' types (slow acting) -anyone know what these are ? Does it sound plausible ?
* New connection to mains
* Earth connection needs to be checked
* To certify, he needs to check all electrics (sockets etc) in the house & rectify any issues.

Does this kind of rework seem typical for a 1988 build? It does have the old
style fuse, but the wiring seems relatively modern otherwise (I opened a few
sockets etc) - I am guessing that if it has issues, any house build before 1990
would have similar problems.
Is this a normal experience if you ask a REC out to just get minor works done?

I actually would not mind getting the fuseboard done, but it is the last bullet
than really bother me - I don't want a whole load of unnecessary rewiring to
sockets etc - it would be a tough house to rewire, loads of chasing required.

Any comments?







* He would need to check the entire house, every socket

2011

It would be necessary to check the wiring before it would be possible to provide definitive comments. Assuming that the house was wired to meet the regulations at the time much of the existing cabling should be ok to reuse, in which case most / all chasing can be avoided. Replacing the distribution board would be a good first step. It really needs an experienced electrician to carry out a thorough inspection. As always use a REC that is recommended to you by someone you trust. Standards vary and some will attempt to overstate what is actually required. Also think about why else you require such as satellite TV requirements, Ethernet points, home automation / IOT requirements, intruder alarm, smoke detectors, carbon monoxide detectors, CCTV, speakers / sound systems etc. It is best to deal with all of this in one go as well as being cheaper.

meercat

If your fuse box is replaced with a distribution board then your mains cables should be upgraded to 16mm. It’s also a requirement that earthing is also upgraded, including new earth rod and all equipotential bonding. When the new board is fitted then every circuit including lights,sockets,cooker etc must be tested in order to provide a certificate to facilitate esbn connection of new mains into the meter. If any issues are discovered then these must be rectified or in some instances a notice of potential hazard may be issued alongside the certificate.

2011

If your fuse box is replaced with a distribution board then your mains cables should be upgraded to 16mm.

They may be 16mm already.

It’s also a requirement that earthing is also upgraded, including new earth rod and all equipotential bonding.

I am open to correction, but I don’t think that earthing requirements have changed since 1988. The earth rod may be ok too.

When the new board is fitted then every circuit including lights,sockets,cooker etc must be tested in order to provide a certificate to facilitate esbn connection of new mains into the meter. If any issues are discovered then these must be rectified or in some instances a notice of potential hazard may be issued alongside the certificate.

+1

niftthelean

Thanks for the info. Seems like the guy was being pretty straight with us. I will get another
opinion all the same I think.