Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Please note that it is not permitted to have referral links posted in your signature. Keep these links contained in the appropriate forum. Thank you.

https://www.boards.ie/discussion/2055940817/signature-rules
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Scratched front bumper

  • 30-04-2019 1:08pm
    #1
    Registered Users, Registered Users 2 Posts: 6,051 ✭✭✭


    While parking, front bumper of my car got scratched against the wall. There are kind of fine threads white lines. I haven't cleaned the area yet, maybe it's mostly white paint from the wall. It looks nasty on a blue coloured car and big enough to be easily noticeable.

    Is there any DIY paint corrector that I should look at first?
    Or any other recommendation please?


Comments

  • Registered Users, Registered Users 2 Posts: 37,269 ✭✭✭✭BorneTobyWilde


    Just clean it and wax it. Could all buff out.


  • Registered Users, Registered Users 2 Posts: 23,157 ✭✭✭✭Alanstrainor


    Clean it off and post a picture here. DIY and bodywork tend to not go well together unfortunately. If it is very light it can be polished out, but I would suspect it's deeper than that.


  • Registered Users, Registered Users 2 Posts: 6,051 ✭✭✭masterboy123


    Alright. I will clean it after work today and put up a picture here.

    Thank you!
    Clean it off and post a picture here. DIY and bodywork tend to not go well together unfortunately. If it is very light it can be polished out, but I would suspect it's deeper than that.


  • Registered Users, Registered Users 2 Posts: 8,933 ✭✭✭jmreire


    Get some cutting compound fro the local motor factors, and try that. If it work's, fine, if not and the scratches have gone through to the primer , it will need re-painting. Don't even think about using polish to try to remove it. Painting any panel after it has been polished,is a difficult job, as the polish can cause many problems. If it compounds out Ok, then you can polish it, as it won't need painting. If the scratches are very light, then you can touch it up using the head of a matchstick, one drop at a time. Don' try to touch it up using a paint brush, or a rattle can ( unless you really know what you are doing.)


  • Registered Users, Registered Users 2 Posts: 6,051 ✭✭✭masterboy123


    Thanks for detailed reply.

    I have:

    Farecla G3 PERMANENT Scratch Remover Paste 150ml.

    I bought it last year from Halfords upon an advise from a Boardie member. Should I try it over the scratch and see if it works?


  • Advertisement
  • Registered Users, Registered Users 2 Posts: 51,481 ✭✭✭✭bazz26


    Post some photos of it but if the scratches are deeper than the lacquer then that scratch repair paste may be useless. Run your fingernail over the scratches and if your nail catches the scratch then it's gone deep below the top lacquer coating.


  • Registered Users, Registered Users 2 Posts: 6,051 ✭✭✭masterboy123


    I have used the paste yesterday. 70% improvement seen.
    I took photos but it was night time and very dark.

    So overall I am happy with the results. And yes it's a deep scratch.


  • Registered Users, Registered Users 2 Posts: 8,933 ✭✭✭jmreire


    I have used the paste yesterday. 70% improvement seen.
    I took photos but it was night time and very dark.

    So overall I am happy with the results. And yes it's a deep scratch.

    Then it's make your mind up time....
    Option1 :- Get some paint, and touch it up with a match stick slowly, bit by bit, just dab a little bit of paint on the scratch, and you might have to do it a few times to completely fill in the scratches ( once you can see white in the scratch, that's the primer you are looking at ) After awhile, the paint will settle in,and become less noticeable. Don't use a paint brush, as this will leave lines, especially if its a Metallic paint.
    Option 2:- If you are really particular about the appearance of your car....then the body-shop is your only answer. But it could work out fairly expensive...plastic bumpers flex, and so all paint materials have to flex as well plus a special primer is needed for use with plastic... its not the same job at all as painting metal panels.
    Good Luck with it.


  • Registered Users, Registered Users 2 Posts: 6,051 ✭✭✭masterboy123


    This was the initial damage. Most of it gone with scratch repair paste and heavy rainy today. There is a grey-black line left now. No white lines.
    See attached picture

    i2v7mo.jpg


  • Registered Users, Registered Users 2 Posts: 8,933 ✭✭✭jmreire


    Its a job for the body shop....it has gone all the way into the plastic. See where the black colour is showing through at the right hand side of the top scrape? That's the actual bumper itself.
    Sorry to be the bringer of bad news,,,,:(


  • Advertisement
  • Registered Users, Registered Users 2 Posts: 6,051 ✭✭✭masterboy123


    Except the black colour showing through at the right hand side of the top scrape, everything else returned to normal. I will try to take a pic tomorrow.


Advertisement