Faulty gas hob help.

James Bond Junior · 22-01-2019 9:29pm #1

I have a whirlpool 4 ring gas hob that has been giving some problems lately. It is connected to a standard yellow calor propane tank outside. It has refused to light a few times, today being one when the flame lit faintly before extinguishing as if the gas just ran out. This has happened before but has worked again the following day as if there was no problem. It has also been lighting and the flame has been VERY high, so much so that it has gone yellow and sooty. Even at its lowest setting the flame was well higher than the normal high setting. It was as if the pressure in the bottle was turned up and the gas was coming out very fast and high. Again the following day it was fine as if nothing had happened. Tt is 3.5 years old at this stage, including orange pipe work and the regulator. Before I go calling an engineer out, any ideas?

anthonyos · 22-01-2019 9:36pm

Is the hob an lpg hob

James Bond Junior · 22-01-2019 9:39pm

anthonyos wrote: »

Is the hob an lpg hob

Butane according to the tank outside. Apologies, thought it was propane.

anthonyos · 22-01-2019 9:49pm

Is the hob setup to burn butane.

James Bond Junior · 22-01-2019 10:21pm

anthonyos wrote: »

Is the hob setup to burn butane.

It has been installed for the past three and a half years without issue.

https://www.appliancesdelivered.ie/whirlpool-600mm-gas-hob-akr-311-ix/1114?gclid=EAIaIQobChMIr-TwiLaC4AIVjQDTCh37PwfkEAQYBCABEgLEP_D_BwE

This is the model I have. A RGI changed the jets for me not long after it was installed by the builder.

23-01-2019 12:18am

Don’t forget butane is a summer gas and doesn’t like the cold.

James Bond Junior · 23-01-2019 10:23am

5c currently and the gas bottle sounds like the liquid is sloshing around inside no problem. Will try bringing it inside for the day to see does that help. Connecting and reconnecting the bottle drew a tiny low flame but wouldn't take.

monseiur · 23-01-2019 12:10pm

Try a different (full) gas tank to rule out any issues with your current tank - also check for any kinks in hose from tank especially at back of cooker.
M.

James Bond Junior · 23-01-2019 12:21pm

monseiur wrote: »

Try a different (full) gas tank to rule out any issues with your current tank - also check for any kinks in hose from tank especially at back of cooker.
M.

Will do. A cylinder normally lasts me about 6 months or so and I only got this 2 months ago but it's around then since these issues have arisen.

Just reconnected the cylinder after it being inside for an hour or so and it is working again just with lower pressure/flame than usual.

my3cents · 23-01-2019 2:17pm

Also replace the regulator they aren't expensive no more than €15 and they don't last forever.

Its probably a Jumbo Gas Regulator you want like this one https://www.topline.ie/garden-outdoors/outdoor-living/bbqs-outdoor-cooking/bbq-accessories/easi-gas/jumbo-gas-regulator

James Bond Junior · 23-01-2019 3:46pm

I wonder would it be a good idea to replace the regulator with a propane conversion. It would appear the problem may be cold weather but I still can't understand why the gas is coming put very occasionally very high and on high a pressure.

my3cents · 23-01-2019 3:52pm

James Bond Junior wrote: »

I wonder would it be a good idea to replace the regulator with a propane conversion. It would appear the problem may be cold weather but I still can't understand why the gas is coming put very occasionally very high and on high a pressure.

Just get a new Jumbo regulator its a quick fix for little cost. I don't think you can get propane easily now that takes a Jumbo regulator so just stick with what has worked for you before.

James Bond Junior · 23-01-2019 3:59pm

my3cents wrote: »

Just get a new Jumbo regulator its a quick fix for little cost. I don't think you can get propane easily now that takes a Jumbo regulator so just stick with what has worked for you before.

Thanks, I'll pick one up tomorrow. I was cooking this afternoon and it was working without issue after bringing the cylinder inside for an hour to warm up. I may as well change the orange pipe too, it is cracking and badly faded.

my3cents · 23-01-2019 4:01pm

Let us know how you get on. Its not always the regulator and this weather it could easily be the temperature but I've seen putting in a new regulator fix similar issues enough times to know its worth doing.

James Bond Junior · 23-01-2019 4:09pm

my3cents wrote: »

Let us know how you get on. Its not always the regulator and this weather it could easily be the temperature but I've seen putting in a new regulator fix similar issues enough times to know its worth doing.

Will do. Are you an RGI do you mind me asking?

my3cents · 23-01-2019 4:12pm

James Bond Junior wrote: »

Will do. Are you an RGI do you mind me asking?

No, but you don't need to be one to change a regulator afaik?

James Bond Junior · 23-01-2019 4:16pm

my3cents wrote: »

No, but you don't need to be one to change a regulator afaik?

No you don't, was just wondering was it sonething you worked at and were familiar with. I did need an RGI to change the jets to LPG compatible however.

my3cents · 23-01-2019 4:28pm

James Bond Junior wrote: »

No you don't, was just wondering was it sonething you worked at and were familiar with. I did need an RGI to change the jets to LPG compatible however.

I'm not sure you did need to change anything? There will be a rating plate on your hob (also in the manual) that states the flow rate and pressure required and I'd take some convincing that you can't use Butane, Propane or LPG without changing the jets provided you had the correct flow rate and pressure, different regulators.

Our own hobs both in our kitchen and caravan will work with Butane, Propane or LPG but need different jets to work with Natural gas.

The only reason I can thin of that your hob would have needed different jets is if it was bought for use with Natural gas.

James Bond Junior · 23-01-2019 4:34pm

When it was bought and initially installed the flame was very high and yellow. I went back to the shop and they told me to change the jets to the other set supplied but I could only get it done by an RGI. This was September 2015 and it was worked flawlessly until the issues which have arisen in the past month or two.

John.G · 23-01-2019 5:22pm

my3cents wrote: »

I'm not sure you did need to change anything? There will be a rating plate on your hob (also in the manual) that states the flow rate and pressure required and I'd take some convincing that you can't use Butane, Propane or LPG without changing the jets provided you had the correct flow rate and pressure, different regulators.

Our own hobs both in our kitchen and caravan will work with Butane, Propane or LPG but need different jets to work with Natural gas.

The only reason I can thin of that your hob would have needed different jets is if it was bought for use with Natural gas.

AFAIK there should be no problem with Butane cylinders (which contain a small % of Propane) at any temperature > -2C.
I have a "Type 682 JGR2 Jumbo Gas Regulator for Butane Gas" 2 kg/hr @ 29 mbar which I have used for a good few years very occasionally during power outages on a 4 burner portable hob.
Would also suggest to renew the regulator.

my3cents · 23-01-2019 5:35pm

James Bond Junior wrote: »

When it was bought and initially installed the flame was very high and yellow. I went back to the shop and they told me to change the jets to the other set supplied but I could only get it done by an RGI. This was September 2015 and it was worked flawlessly until the issues which have arisen in the past month or two.

iirc Natural gas is supplied at a lower pressure so has larger jet size compared with LPG (Butane/Propane or a mix) so too much gas would get through if you initially had jets installed for Natural gas, hence the high yellow flame.

The jets you have now will work with Butane Propane or LPG.

Faulty gas hob help.

Comments