Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Insulated thermal board

  • 13-01-2019 9:06pm
    #1
    Registered Users, Registered Users 2 Posts: 211 ✭✭


    Hi I need to move a plug socket over to a finished 64mm thermal board wall. Would it be okay to cut a track in the plasterboard and remove some insulation before putting the cable in conduit and then plastering over it? thanks.


Comments

  • Registered Users, Registered Users 2 Posts: 5,401 ✭✭✭DublinDilbert


    Hi I need to move a plug socket over to a finished 64mm thermal board wall. Would it be okay to cut a track in the plasterboard and remove some insulation before putting the cable in conduit and then plastering over it? thanks.

    Not ideal as the integrity of the board would be compromised. How long is the run?

    For a short run you might be able to shove a pipe or something up through the insulation making a channel for the cable


  • Registered Users, Registered Users 2 Posts: 211 ✭✭Johnnycanyon


    Not ideal as the integrity of the board would be compromised. How long is the run?

    For a short run you might be able to shove a pipe or something up through the insulation making a channel for the cable

    It would be down to counter level but because the roof is flat I would be unable to shove a pipe down from above.. I didn't think cutting a Grove in the plasterboard would be a problem as switch and plug boxes are all cut out anyway. There would be a couple of inches of insulation behind the conduit and new plaster over the cut out groove. I was more wondering about this from an electrical point of view.. thanks


  • Registered Users, Registered Users 2 Posts: 5,401 ✭✭✭DublinDilbert


    Is there another route you can take to get the cable down behind the counter then come back up to where the switch/socket should be from under the counter. Is there another cable chase you could come down?


    Seems like a lot of hard work to patch up the slab and trying to get it looking like new again.


  • Registered Users, Registered Users 2 Posts: 211 ✭✭Johnnycanyon


    Is there another route you can take to get the cable down behind the counter then come back up to where the switch/socket should be from under the counter. Is there another cable chase you could come down?


    Seems like a lot of hard work to patch up the slab and trying to get it looking like new again.

    Only way is from top ,but with cabinets on wall and tiles going over work top it would leave very little patching which would be out of sight on top of cabinets..


Advertisement