Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

starting a ford 7000

  • 01-07-2018 2:05pm
    #1
    coyle21
    Registered Users, Registered Users 2 Posts: 222 ✭✭


    what the correct procedure for starting these when they run out of diesel


Comments

  • #2
    Dakota Dan
    Registered Users, Registered Users 2 Posts: 3,778 ✭✭✭Dakota Dan


    Open the bleed screw on the filter pull out the stopper and crank the engine until diesel comes out bubble free. Close bleed screw use primer pump to get diesel to fuel pump. open throttle fully push in button on the stopper on the fuel pump and crank the engine again.


  • #3
    coyle21
    Registered Users, Registered Users 2 Posts: 222 ✭✭coyle21


    Dakota Dan wrote: »
    Open the bleed screw on the filter pull out the stopper and crank the engine until diesel comes out bubble free. Close bleed screw use primer pump to get diesel to fuel pump. open throttle fully push in button on the stopper on the fuel pump and crank the engine again.

    ta, no primer pump on this one, so no need to open any injectors then


  • #4
    trabpc
    Registered Users, Registered Users 2 Posts: 947 ✭✭✭trabpc


    Should be a little screw on the side of the injector pump. Screw it out and prime till all the air is out. Is it the original engine?


  • #5
    coyle21
    Registered Users, Registered Users 2 Posts: 222 ✭✭coyle21


    trabpc wrote: »
    Should be a little screw on the side of the injector pump. Screw it out and prime till all the air is out. Is it the original engine?

    not sure, engine has red block with X on it


  • #6
    Dakota Dan
    Registered Users, Registered Users 2 Posts: 3,778 ✭✭✭Dakota Dan


    coyle21 wrote: »
    ta, no primer pump on this one, so no need to open any injectors then
    Is it an inline or rotary pump?


  • Advertisement
  • #7
    Dakota Dan
    Registered Users, Registered Users 2 Posts: 3,778 ✭✭✭Dakota Dan


    This video explains it only don't go tightening the injector nuts with your hand as diesel is coming out at pressure, use a spanner. Usually you only need to loosen the front injector nut.

    https://m.youtube.com/watch?v=7M2RKDtcmBs


Advertisement