Back boiler/chimney

RockDesk

Hi,

We have a back boiler that is broken and is installed beside/built into the chimney breast. The chimney/fireplace isn't used.

Is it correct that if we wanted to use the fire again, it would be dangerous having the broken boiler beside it?

If so, who do get to remove it, and how much approx would it cost for removal?

The chimney hasn't been used for fire for over 15 years so will need a full check and possible repair so I don't know if it's worth it if I'll end up spending a fortune on it.

Wearb

You are correct that it would be dangerous, unless it was properly decommissioned...a rare thing.

You should look in local ads, ask friends or local builders merchants for recommendations for someone to remove it.

RockDesk

Grand, thanks for the reply.

So it would just be a builder that I'd get remove it, I don't need a boiler specialist (plumber?)

Wearb

RockDesk wrote: »

Grand, thanks for the reply.

So it would just be a builder that I'd get remove it, I don't need a boiler specialist (plumber?)

A plumber would most likely tackle the job as well. Once you get a few names, just explain what you need done and you will be told if they can do it or not.

Just don't listen to anybody telling you that just cutting off the water to it will be fine. Constrained boiling water or heated air will eventually explode.

RockDesk

Ok. So I want it removed completely.

I'm glad I checked here, because I don't know about any of the back boiler stuff so could have gone with disconnection, especially if it worked out cheaper.

Thanks again for your replies, it's been very helpful.