Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Please note that it is not permitted to have referral links posted in your signature. Keep these links contained in the appropriate forum. Thank you.

https://www.boards.ie/discussion/2055940817/signature-rules
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Car doors hard to open in frost

  • 07-01-2018 11:42am
    #1
    Registered Users, Registered Users 2 Posts: 1,189 ✭✭✭


    Anything simple that can be done to prevent car doors being hard to open after a hard nights frost?


Comments

  • Closed Accounts Posts: 9,764 ✭✭✭my3cents


    If its the door deals sticking with ice get some silicon spray lubricant (silicon not oil) spray it on a cloth like you were polishing furniture and then wipe over the rubber door seals with it.


  • Registered Users, Registered Users 2 Posts: 34,685 ✭✭✭✭NIMAN


    Once had a work colleague advise me to apply some grease to the rubber door deals.

    Never tried it to be honest.


  • Registered Users, Registered Users 2 Posts: 24,644 ✭✭✭✭punisher5112


    Vaseline would work.


  • Registered Users, Registered Users 2 Posts: 34,685 ✭✭✭✭NIMAN


    Vaseline would work.

    :eek:
    FFS man, stop changing the subject, he's chatting about stuck car doors.


  • Registered Users, Registered Users 2 Posts: 81,220 ✭✭✭✭biko


    Any motor factors will have silicone spray.


  • Advertisement
  • Closed Accounts Posts: 9,764 ✭✭✭my3cents


    It might also be worth mentioning that you should clean the door frame and door rubbers first and make sure any water drain points are clear so there is no water building up ready to freeze in cold weather. The silicon lube is just the icing on the cake that keeps the water away from the rubbers while providing a non stick lubricated surface, use it very sparingly. Also bare in mind that you need to get a silicon spray that says its OK to use on rubber door seals. Some silicon sprays contain solvents that aren't good for the rubber.

    Then there is the possibility your door seals have worn out gone porous and are holding water anyway so again silicon will help but may need applying more often.

    Edit> As an example this one should be fine https://www.amazon.co.uk/WD-40-Specialist-Performance-Silicone-400ml/ but its not the same as the usual blue can WD40.


  • Registered Users, Registered Users 2 Posts: 1,189 ✭✭✭ruwithme


    Thanks for the replys.will try the silicone lube.


  • Registered Users, Registered Users 2 Posts: 4,777 ✭✭✭meathstevie


    A lot simpler than spraying or smearing anything on it. Push the door before opening it. That tends to break the seal the ice formed on the rubber... .


  • Registered Users, Registered Users 2 Posts: 8,532 ✭✭✭JohnBoy26


    NIMAN wrote: »
    Once had a work colleague advise me to apply some grease to the rubber door deals.

    Never tried it to be honest
    .

    Weren't you lucky


Advertisement